Kronalux® Aqua Fluid Plastic 783
Water-thinnable floor coating for floors, stairs and basements
- for interior and exterior use
- easy to apply
- fast drying
- light and weather resistant
- impact, shock and abrasion resistant
- very good adhesion
- resistant to common household chemicals
- high hiding power
Universal, pigmented floor paint for interior and exterior surfaces subject to normal wear and tear in private or commercial applications, e.g. basement rooms, stairs, covered balconies and walkways, etc. Suitable for coating concrete, cement screed, asbestos cement, steel, wood and many plastics. Kronalux® Aqua liquid plastic is available in the colours silver-grey, stone-grey and pebble-grey.
For technical reasons, the colours on the monitor/display are not binding. Please refer to the colour chart for binding colours.
Preparation of the substrate
Concrete, plaster and asbestos cement should be 4–6 weeks old by the time the painting work begins. The substrate must be clean, dry, grease-free, grippy and stable; loose and crumbling layers must be removed. Concrete and cement plaster must still have sufficient absorbency to ensure adhesion. Any cement paste or sinter layers on the surface must be removed by sandblasting or mechanical roughening. It is best to clean contaminated concrete surfaces by brushing them with an active cleaner such as Jaeger Special Cleaner 080. Then wash with plenty of water or a steam cleaner. Finally, allow the surfaces to dry thoroughly. For deep-seated contamination, appropriate remediation measures should be taken. Adverse effects of moisture on the rear side (groundwater) impair adhesion.
Plastic: Due to the wide variety of plastics, we always recommend a preliminary test.
Steel: Remove rust and grease and prime with Multigrund 715, Multigrund Spray 714 or Aqua Multigrund 716.
Old coatings: Clean and sand down and check for compatibility and adhesion (test coat).
Floor coating: Prime untreated floors in advance with Special Primer Resin 864.
Technical details
Thinning/tool cleaning: The product is ready for use. Clean tools with water and soap immediately after use.
Drying (at 20°C/55% relative humidity)
Dust-dry approx. 60 min.
Touch-dry approx. 3–6 hours
Can be painted over after approx. 12 hours
Fully resilient 7–10 days
product data
spreading rate
| paint/roll | spraying |
|---|---|
| 6-8 m²/l |
item number/shade
| item number | shade |
|---|---|
| 7837001 | silver-grey |
| 7837030 | stone-grey |
| 7837032 | pebble-grey |
size of trading unit/box content
| size of trading unit | box content |
|---|---|
| 750 ml | 3 |
| 2,5 l | 2 |
| 10 l | 1 |
| 750 ml | 3 |
| 2,5 l | 2 |
suitable products
